Each port can provide up to 30 watts max. Ports 8 (on XGS 116(w) and 11/12 (on XGS 126(w)/136(w) are able to provide power over Ethernet (PoE) to a connected PoE device which conforms to the standards 802.3af (max. After synchronization, you will see a screen with the message, “Synchronization with server was successful.” ‘Synchronize License’ only after the appliance is successfully registered.Ĭlick ‘Initiate License Synchronization’ to get the license information from Sophos onto the appliance. Please note that you should proceed with the next step, i.e. After successful registration, you will see a screen with the message, ‘Your device is now registered’. Please wait while the process completes – it will take a few seconds. If you are a new user, sign up for a MySophos account by entering the details under ‘Register for MySophos’.Ĭlick ‘Continue’ to complete the registration process. If you already have a MySophos account, enter your login credentials under ‘Log in to MySophos’. If you are upgrading from an existing UTM/SG appliance and want to migrate your existing UTM license to your new firewall, click the respective button on the screen and browse for your UTM license to upload it to your firewall.Īfter clicking ‘Continue’, you will be redirected to the MySophos portal. If you have a serial number provided on your License Schedule please enter it into the first field and click “I have an existing serial number,” otherwise click “I don’t have a serial number (Start a Trial).” If you want to register later, click the check box “I do not want to register now” and proceed with section c). If you have not previously registered your appliance on MySophos, you will see the registration screen “Register Your Firewall.” The appliance requires Internet connectivity for it to be registered with MySophos. Change the interface IP addresses, default gateway, DNS settings and date/time zone to match your local network settings. Select ‘Click to begin’ on the ‘Welcome’ screen to start your basic appliance configuration. Start the browser and enter the IP address of the appliance’s LAN port that your PC is connected to: DNS Server: Enable this option and enter the IP address of the internal network card (Port1/LAN): 172.16.16.16Ĭonnect your PC/laptop to Port 1/LAN of the appliance:.Default Gateway: Enter the IP address of the appliance’s internal network card (Port1/LAN): 172.16.16.16.Use the settings below to configure your (PC/laptop) network interface: Once the device has booted completely the Status LED will turn to solid green. During boot up the Status LED on the front will blink green. The power switch is on the back of the appliance near the power connection. Power Up the ApplianceĬonnect the power cable and turn on the applianceĬonnect the appliance to the power supply using the power cable(s). If you want to mount the device within a rack please use the optionally available rackmount kit for this device. XGS appliances are shipped with the following default settings: The connection to the WAN depends on the type of Internet access.
0 Comments
Leave a Reply. |